Control 50 Devices
To control 50 devices, the following computer configurations are recommended ( How to check the computer configuration )
| CPU | i5 (Intel I10400 series) and above |
| Memory | 8G or more |
| Motherboard | ASUS large boards with USB 3.0 or USB 3.1 ports * Usually the usb connector on the back of the host is black for USB 2.0, blue for USB3.0, blue-green or red for USB3.1 |
| Operating System | Recommended for Win10 * For Win7, disable xHCI mode to avoid device limits. |
| Graphics Card | CPU Built-in Graphics or 1060 6G |
| Monitor | 2K/4K to view more devices on the same screen |
| USB Interface | 1 motherboard USB port (USB3.0/USB3.1) + 1 PCI-E card / 2 PCI-E cards Either one * PCI-E cards are recommended to use USB 3.1 interface with independent power supply.  |
| Hub | 10-Port Hub (120W) 5 units |
|
Note: 1. The power supplied by the Hub to each device must exceed 12W, otherwise, the device will disconnect during testing. For example, a 10-port Hub requires at least 120W total power.
2. ASUS motherboards can typically recognize about 40 devices, first-tier motherboards like Gigabyte can recognize about 20 devices, and other motherboards can generally recognize about 10 devices. If you need to connect more devices, please insert a PCIe to USB expansion card into the motherboard.
3. A PCIe x1 to USB 3.0 card can typically connect 5 to 10 additional devices, and a PCIe x4 to USB 3.1 card can typically connect 40 additional devices, with specific numbers depending on actual parameters. We recommend using the PCIe x4 to USB 3.1 card of MOGE, which can connect about 40 additional devices. Therefore, the motherboard needs to reserve the corresponding slots (PCIe x16 compatible with PCIe x4).
4. It is recommended to use ASUS motherboards and Intel I series CPUs.
5. After disabling XHCI USB 3.0 in the BIOS settings, the number of devices the motherboard can directly connect may increase slightly.
6. To display all devices on one screen, please refer to the above monitor configuration. If multiple page displays are acceptable, you can also use monitors with lower resolutions.
|
|
Total Control is compatible with Android devices of all brands and manufacturers, but to simplify your work and avoid unnecessary debugging processes, we recommend:
Tip: You can first acquire a device, connect it to Total Contol and test it correctly, then make a bulk acquisition.
5 * 10-Port Hubs
To connect 50 devices to the computer, five 10-port Hubs are needed. Simply connect the 50 devices to the Hubs, and then connect the Hubs to the computer's USB ports (including USB ports expanded by PCIe cards).
Note: The Hub must provide over 12W per device to prevent disconnections during testing. For example, a 10-port Hub needs a total power supply of 120W. Connect the Hubs to the USB 3.0 ports on the back of the computer case (including USB ports expanded by PCIe cards). Use high-quality USB cables to avoid disconnections.
After the hardware is installed, we can install and debug the software.